I have tried another X-Server application in a NT O.S. type of
environment, and I still can't get the X11 forwarding to work.
I'm therefore going to be very specific in the steps I have performed to
try and get this to work.
It work fine when I tried to connect to a Unix server directly, without
doing X11 forwarding.
I'm not testing this with Omni-X X-Server and this is how I have
configure it.
a). XDMCP Query mode is what doesn't work for me, when I use XDMCP
Broadcast it works but then I'm not doing X11 forwarding over SSH.
b). I then set up the remote host as the "local host" thus 127.0.0.1
That's it on the X-Server side.
Next I went into the TTSSH program and this is how it is configured.
a). I configure under setup, SSH forwarding on local port 6000 to remote
host IP#.#.#.# and on the same port.
b). I placed a check mark at the bottom to "Display remote X applications
on local X-Server."
I have been told that this may not be working for the following reason by
one individual, but I don't have enough knowledge and I can not find enough
information about this topic anywhere:
This individual told me that I need to configure the sshd on the Unix side
to accept XDMCP-Query, however I don't know where to begin to make such a
change on the Unix Server. Secondly why would it be working fine when I
connect using the
XDMCP-Broadcast ?
If anyone has this working properly please forward your steps to me, I
don't know where else to look. I'm considering purchasing the SSH Unix
book that was recommended, but they told me that I would need a special
order which could take weeks.
Thanks everyone.
