Chris Bagnall a écrit :
We are currently using vlans because we have VoIP services going through
this and different kind of users. Everything is working OK as of now.
However, the max bandwidth of one WiFi link like that is about 10 mbps.
To increase the total bandwidth, we want to add another antenna in
Building 1.
I don't know the layout of the buildings, but have you considered using
point-to-point laser links between the buildings? I was involved in a project
at a site earlier this year that was happily getting 100mbps between buildings
using roof-mounted lasers.
Much lower latency than 802.11a/b/g as well (assuming that's what you're using).
If you do stick with WiFi, I'd not worry too much about the downtime - a) it
should only be a few minutes, and b) it can probably be managed such that it's
done during off peak hours.
Can you give us any more information about the WiFi hardware at each end? I'm
not sure simple port trunking on the switches (which is what I guess you're
suggesting in the first approach) is going to do the job if the WiFi devices
are essentially standard APs, since I presume they'd have their own IP
addresses?
If the WiFi devices were operating at a lower level than IP, it'd probably
work, possibly if they were using some sort of L2TP tunnelling internally?
(though you might then have to consider packet fragmentation, depending on the
packet size)
The antennas are SkyPilots. They do have an IP address, for
configuration, but I think they could also be configured via console.
Thanks a lot for your input on this OT matter :).
Ugo
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
Commercial support available - https://portal.pfsense.org