I just picked up a 2 meg pci ATI mach 64 card, installed the mach 64
server, ran xf86config to direct it to the new server... no problem.
problem---> I seem to have lost about 1 inch from the top of my monitor
and a little from the bottom!
the resolution is640x480 800x600 1024x1024 all the same for
8bpp/16/24/32
The previous setup was an onboard card (this is on a compaq deskpro p90)
with Im assuming 1M ram
the difference in resolution is *slight* compared to my onboard setup
I was told that a 2M would be more than adequate for web browsing,
xgames etc, but the difference is minimal and Im not really happy about
loosing an inch from my screen...
did I miss something in the configuration? Was I "misguided"?
any suggestions?
thanks
rob
Linux Home page http://www.connix.com/~dizzy73/LBM.htm
-
To get out of this list, please send email to [EMAIL PROTECTED] with
this text in its body: unsubscribe suse-linux-e
Check out the SuSE-FAQ at http://www.suse.com/Support/Doku/FAQ/ and the
archiv at http://www.suse.com/Mailinglists/suse-linux-e/index.html
