Have you tried playing with the controls on your monitor. There should be
several , that will controll width , hight , ect... This may help solve
your problem.
Hope this helps.
Samy
At 06:14 PM 12/29/1998 -0500, you wrote:
>
>I just picked up a 2 meg pci ATI mach 64 card, installed the mach 64
>server, ran xf86config to direct it to the new server... no problem.
>problem---> I seem to have lost about 1 inch from the top of my monitor
>and a little from the bottom!
>the resolution is640x480 800x600 1024x1024 all the same for
>8bpp/16/24/32
>The previous setup was an onboard card (this is on a compaq deskpro p90)
>with Im assuming 1M ram
>the difference in resolution is *slight* compared to my onboard setup
>I was told that a 2M would be more than adequate for web browsing,
>xgames etc, but the difference is minimal and Im not really happy about
>loosing an inch from my screen...
>did I miss something in the configuration? Was I "misguided"?
>any suggestions?
>thanks
>rob
>
>Linux Home page http://www.connix.com/~dizzy73/LBM.htm
>
>
>-
>To get out of this list, please send email to [EMAIL PROTECTED] with
>this text in its body: unsubscribe suse-linux-e
>Check out the SuSE-FAQ at http://www.suse.com/Support/Doku/FAQ/ and the
>archiv at http://www.suse.com/Mailinglists/suse-linux-e/index.html
>
>
-
To get out of this list, please send email to [EMAIL PROTECTED] with
this text in its body: unsubscribe suse-linux-e
Check out the SuSE-FAQ at http://www.suse.com/Support/Doku/FAQ/ and the
archiv at http://www.suse.com/Mailinglists/suse-linux-e/index.html
