Hi I would not do anything that's not reversible. You may well come across a FRS-C that's got a good lamp and dead electronics.
Of course given what telco Rb's cost these days .... Bob On Jan 20, 2011, at 10:47 PM, paul swed wrote: > Well I think bad news. > I have a frs c apart. Unfortunately the rb lamp doesn't even light at all. I > have been getting RF at about 80.5 Mhz though at the moment I am not. I do > not see any residue on the bulb. > On one of the websites I did see that the lamp should run outside of the > oven. Granted not correctly but should ignite. I guess my low lamp V was > really saying no lamp. So my fear is this really is not recoverable. > I plan to dig into the oscillator tomorrow to see whats up. > Regards > Paul > WB8TSL > > > On Wed, Jan 12, 2011 at 3:09 PM, Bruce Griffiths <bruce.griffi...@xtra.co.nz >> wrote: > >> Magnus Danielson wrote: >> >>> On 12/01/11 18:41, paul swed wrote: >>> >>>> Did you use a large heat gun or the smaller ones for heat shrink. >>>> I might guess the smaller one >>>> >>> >>> I have a smaller one so that was what I used and it was more than >>> sufficient. I will get a large one too, but with some propper effect >>> control. >>> >>> Cheers, >>> Magnus >>> >>> Just wire a dimmer in series with the heater element. >> >> Bruce >> >> >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.