On Mon, May 19, 2014 at 10:06 AM, KJ H. Kiran <kj.h.ki...@us.abb.com> wrote: > > Hi , > > > I am trying to make a eval board from TI to boot it with the new FIT image > format. > > > I have followed the below procedure but iam getting the "No valid FDT found - > please append one to U-Boot binary, use u-boot-dtb.bin or define > CONFIG_OF_EMBED." error message. Cannot find out what is the exact problem. >
This shouldn't be an issue with FIT - issue with booting u-boot fdt bin Just for FIT work usage - try to boot with u-boot.bin (fdt less u-boot bin) So-that you can end up with normal u-boot booting. On u-boot prompt and load u-boot-fdt.bin with TEXTBASE then load u-boot> fatload mmc 0 ${TEXTBASE} u-boot-fdt.bin u-boot> go ${TEXTBASE} ------ fdt u-boot boot prompt> u-boot> fatload mmc 0 ${LOADADDR} kernel_fdt.itb u-boot> bootm ${LOADADDR} ..... Please send output log for this. > > U-Boot Source: > > The latest source code from denx. > > patman: Suppress duplicate signoffs only for real patches on 05/17/2014 > > > Procedure: > > Followed the exact same process mentioned in > > http://www.denx.de/wiki/pub/U-Boot/MiniSummitELCE2013/U-Boot_verified_RSA_boot_flow_on_arm_target.pdf > > > I created a device tree and was able to generate a u-boot-dtb.bin file. > > > SD CARD: > > 1) copied the MLO in /boot > > 2) copied the u-boot-dtb.bin in /boot > > 3) coped the kernel_fdt.itb file > > 4) uEnv has > > console=ttyO0,115200n8 > fitfdt=/boot/kernel_fdt.itb > setenv loadaddr 0x82000000; run mmcargs; ext2load mmc ${mmcdev}:2 ${loadaddr} > ${fitfdt}; > > > I loaded the u-boot-dtb.bin file but it still complains ! Not much help form > the forums/internet > > > Please let me know if i missed anything here. thanks! -- Jagan. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot