From: Fabio Estevam <fabio.este...@nxp.com>
There is no need call setup_display() from SPL code, so move it to
board_init(), which executes only in U-Boot proper.
Reported-by: Stefano Babic <sba...@denx.de>
Signed-off-by: Fabio Estevam <fabio.este...@nxp.com>
---
board/wandboard/wandboard.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/board/wandboard/wandboard.c b/board/wandboard/wandboard.c
index adfcf48..dde4988 100644
--- a/board/wandboard/wandboard.c
+++ b/board/wandboard/wandboard.c
@@ -376,9 +376,6 @@ int board_eth_init(bd_t *bis)
int board_early_init_f(void)
{
setup_iomux_uart();
-#if defined(CONFIG_VIDEO_IPUV3)
- setup_display();
-#endif
#ifdef CONFIG_SATA
/* Only mx6q wandboard has SATA */
if (is_cpu_type(MXC_CPU_MX6Q))
@@ -448,6 +445,8 @@ int board_init(void)
setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6q_i2c2_pad_info);
else
setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6dl_i2c2_pad_info);
+
+ setup_display();
#endif
return 0;
--
2.7.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
