Hi Peng and Ye Li, On Sun, May 3, 2020 at 10:57 AM Peng Fan <peng....@nxp.com> wrote: > > From: Ye Li <ye...@nxp.com> > > i.MX8MP thermal which has two probes and supports temperature range > from -40 to 125. The driver still uses default 1p HW > calibration at 25C and loads calibration parameters from fuse. > > Reviewed-by: Peng Fan <peng....@nxp.com> > Signed-off-by: Ye Li <ye...@nxp.com> > Signed-off-by: Peng Fan <peng....@nxp.com>
Are you able to boot an NXP 5.4.3 kernel on a i.MX8MP EVK board? I am getting a kernel hang right after the serial console is probed: https://pastebin.com/3AtvJqWS Any suggestions? I am using ATF from 5.4.3, firmware version is 8.6 and I pass 'export ATF_LOAD_ADDR=0x960000'. Any ideas? Thanks