Hi Fabio, > Subject: Re: [PATCH 10/13] imx: load calibration parameters from fuse for > i.MX8MP > > Hi Peng and Ye Li, > > On Sun, May 3, 2020 at 10:57 AM Peng Fan <peng....@nxp.com> wrote: > > > > From: Ye Li <ye...@nxp.com> > > > > i.MX8MP thermal which has two probes and supports temperature range > > from -40 to 125. The driver still uses default 1p HW calibration at > > 25C and loads calibration parameters from fuse. > > > > Reviewed-by: Peng Fan <peng....@nxp.com> > > Signed-off-by: Ye Li <ye...@nxp.com> > > Signed-off-by: Peng Fan <peng....@nxp.com> > > Are you able to boot an NXP 5.4.3 kernel on a i.MX8MP EVK board? >
5.4.3 upstream kernel + latest upstream uboot? > I am getting a kernel hang right after the serial console is probed: > https://eur01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fpasteb > in.com%2F3AtvJqWS&data=02%7C01%7Cpeng.fan%40nxp.com%7Cf3d1 > e46ad41e4ca90b0608d7ef73f349%7C686ea1d3bc2b4c6fa92cd99c5c301635 > %7C0%7C0%7C637241153594873754&sdata=gjGygSnftYVH58eLW%2By > 6ZZ4uczLZUM0U0lUk9LQyx5Y%3D&reserved=0 > > Any suggestions? > > I am using ATF from 5.4.3, firmware version is 8.6 and I pass 'export > ATF_LOAD_ADDR=0x960000'. > > Any ideas? I am not holiday, not have a board at handle. I will give a try in a few days. Disable busfreq, try clk_ignore_unused? Regards, Peng. > > Thanks