Hi Konstantin,

Yes, I suspect there may be an issue with a configuration or change to the SSH 
configs on your current image. Starting with a fresh release-4 image should 
resolve the issue.


Regards,
Nate Temple


> On Aug 3, 2017, at 12:17 PM, Matheou, Konstantin J. (GRC-LCI0)[ZIN 
> TECHNOLOGIES INC] <konstantin.j.math...@nasa.gov> wrote:
> 
> Nate,  Thanks for all the info..
> 
> I just want to refresh your memory that I was able to connect via serial 
> port...  Only root was needed and no password was needed... so that worked 
> fine.. because this is how I altered the IP address of the E310.
> 
> So with that stated, should I just jump t refreshing the SD card - step 2?
> 
> -----Original Message-----
> From: Nate Temple [mailto:nate.tem...@ettus.com] 
> Sent: Thursday, August 03, 2017 3:14 PM
> To: Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] 
> <konstantin.j.math...@nasa.gov>
> Cc: Philip Balister <phi...@balister.org>; usrp-users@lists.ettus.com
> Subject: Re: [USRP-users] When ssh'ing Getting prompt for Password Issue
> 
> Hi Konstantin,
> 
> You can try connecting via the Serial port [1]. I would suggest to first try 
> undoing any changes you have made to the ssh_config. By default it will not 
> require any passwords.
> 
> If that is not successful, I would suggest downloading a fresh release-4 
> image from [2] and writing it to the SD Card. The SD Card section [3] of the 
> Ettus KB will detail which image you need based on your device serial number.
> 
> [1] - 
> https://kb.ettus.com/Ettus_USRP_E300_Embedded_Family_Getting_Started_Guides#Serial_Console_Connectivity
> [2] - http://files.ettus.com/e3xx_images/
> [3] - 
> https://kb.ettus.com/Ettus_USRP_E300_Embedded_Family_Hardware_Resources#SD_Card_Images
> 
> Regards,
> Nate Temple
> 
> 
>> On Aug 3, 2017, at 12:06 PM, Matheou, Konstantin J. (GRC-LCI0)[ZIN 
>> TECHNOLOGIES INC] <konstantin.j.math...@nasa.gov> wrote:
>> 
>> OK.. I did it your way and I am connecting via ping your way now too....
>> 
>> Bu again, when I do the ssh command, it is asking for a password.
>> 
>> So, I am getting the samething as I was before...
>> 
>> Does ssh have to be setup on the E310???
>> 
>> Is there a way to check/reset the password on the E310?
>> 
>> Thanks
>> 
>> 
>> 
>> -----Original Message-----
>> From: Nate Temple [mailto:nate.tem...@ettus.com]
>> Sent: Thursday, August 03, 2017 2:54 PM
>> To: Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] 
>> <konstantin.j.math...@nasa.gov>
>> Cc: Philip Balister <phi...@balister.org>; usrp-users@lists.ettus.com
>> Subject: Re: [USRP-users] When ssh'ing Getting prompt for Password 
>> Issue
>> 
>> Hi Konstantin,
>> 
>> After setting the NIC to be Bridged for the VM from VirtualBox, you need to 
>> start the VM, then within the System Settings -> Network of the VM, manually 
>> set the NIC to have a static IP address. 
>> 
>> Regards,
>> Nate Temple
>> 
>> 
>>> On Aug 3, 2017, at 11:50 AM, Matheou, Konstantin J. (GRC-LCI0)[ZIN 
>>> TECHNOLOGIES INC] <konstantin.j.math...@nasa.gov> wrote:
>>> 
>>> The Software does not allow me to do that.. Here is a screen shot..  
>>> This is all that it offers…
>>> 
>>> <image001.png>
>>> 
>>> -----Original Message-----
>>> From: Nate Temple [mailto:nate.tem...@ettus.com]
>>> Sent: Thursday, August 03, 2017 2:48 PM
>>> To: Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] 
>>> <konstantin.j.math...@nasa.gov>
>>> Cc: Philip Balister <phi...@balister.org>; usrp-users@lists.ettus.com
>>> Subject: Re: [USRP-users] When ssh'ing Getting prompt for Password 
>>> Issue
>>> 
>>> Hi Konstantin,
>>> 
>>> When operating in bridged mode, did you manually set the (static) IP 
>>> address within your VM?
>>> 
>>> Regards,
>>> Nate Temple
>>> 
>>>> On Aug 3, 2017, at 11:27 AM, Matheou, Konstantin J. (GRC-LCI0)[ZIN 
>>>> TECHNOLOGIES INC] <konstantin.j.math...@nasa.gov> wrote:
>>>> 
>>>> Nate,
>>>> 
>>>> As soon I put it into bridged mode, nothing works..  What I mean is that I 
>>>> am not able to communicate/ping to the E310 that way.
>>>> 
>>>> It may work maybe for other VM software, but again, I am using Oracle 
>>>> VirtualBox.
>>>> 
>>>> Thanks
>>>> 
>>>> -----Original Message-----
>>>> From: Nate Temple [mailto:nate.tem...@ettus.com]
>>>> Sent: Thursday, August 03, 2017 1:37 PM
>>>> To: Philip Balister <phi...@balister.org>
>>>> Cc: Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] 
>>>> <konstantin.j.math...@nasa.gov>; usrp-users@lists.ettus.com
>>>> Subject: Re: [USRP-users] When ssh'ing Getting prompt for Password 
>>>> Issue
>>>> 
>>>> Hi Konstantin,
>>>> 
>>>> You may want to try putting your VM into a Bridge Network mode. There may 
>>>> be an issue with the NAT routing. If operating in Bridged mode, ensure 
>>>> your Host, VM and E3xx all have different IP addresses.
>>>> 
>>>> Regards,
>>>> Nate Temple
>>>> 
>>>> 
>>>> 
>>>>> On Aug 3, 2017, at 9:39 AM, Philip Balister via USRP-users 
>>>>> <usrp-users@lists.ettus.com> wrote:
>>>>> 
>>>>> On 08/03/2017 11:07 AM, Matheou, Konstantin J. (GRC-LCI0)[ZIN 
>>>>> TECHNOLOGIES INC] via USRP-users wrote:
>>>>>> Hello All,
>>>>>> 
>>>>>> I have the E310 hooked up with an Ethernet wire, and I can ping from my 
>>>>>> Linux Ubuntu Virtual machine (created by Oracle VirtualBox software).
>>>>>> 
>>>>>> But when I try to SSH, I did get access denied.. until I added a  VM 
>>>>>> rule for port 22 in Network Settings of the VM.
>>>>>> 
>>>>>> But now I get the password message in the Linux terminal to place a 
>>>>>> password.  As we know, the password is empty per the instructions on the 
>>>>>> website.
>>>>> 
>>>>> Did you hit return to see if it gave you a prompt?
>>>>> 
>>>>> Philip
>>>>> 
>>>>>> 
>>>>>> So I went into ssh_config file in Linux at ect/ssh and altered a 
>>>>>> line that allows for no passwords... This is the site..
>>>>>> http://developer.toradex.com/knowledge-base/ssh
>>>>>> 
>>>>>> But I am still not getting past the password login.
>>>>>> 
>>>>>> Is there any other advice you can give me?
>>>>>> 
>>>>>> Thanks,
>>>>>> 
>>>>>> Konstantin
>>>>>> 
>>>>>> 
>>>>>> 
>>>>>> 
>>>>>> _______________________________________________
>>>>>> USRP-users mailing list
>>>>>> USRP-users@lists.ettus.com
>>>>>> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>>>>>> 
>>>>> 
>>>>> _______________________________________________
>>>>> USRP-users mailing list
>>>>> USRP-users@lists.ettus.com
>>>>> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>>>> 
>> 
> 


_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
  • Re:... Philip Balister via USRP-users
    • ... Nate Temple via USRP-users
      • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
        • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
        • ... Nate Temple via USRP-users
          • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
            • ... Nate Temple via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Nate Temple via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Nate Temple via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Nate Temple via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Derek Kozel via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Derek Kozel via USRP-users
              • ... Matheou, Konstantin J. (GRC-LCI0)[ZIN TECHNOLOGIES INC] via USRP-users
              • ... Derek Kozel via USRP-users

Reply via email to