Dear all I want to jump into this conversation as I experience similar behaviour with a WBX-120 on the X310. When sending a stream of 0's, the peak power is still -50dBm (cw) at the tune frequency. When running the calibration command on UHD 4.6 i get an error that CAL antenna is not available, while it is shown when running uhd_usrp_probe (made a issue on github for uhd driver). Curious about the manual calibration procedure.
All the best Tim Vancauwenbergh ________________________________ Van: Cédric Hannotier via USRP-users <[email protected]> Verstuurd: donderdag, februari 29, 2024 4:05:50 p.m. Aan: zhou <[email protected]> CC: [email protected] <[email protected]>; Pedro Vieira <[email protected]> Onderwerp: [USRP-users] Re: OFDM signal transmission by x310 presents a peak Hi Hongwei, On 2024-02-26 10:06 +0000, zhou wrote: > For X310 USRPs, you need to loopback connect the antenna ports. Could you direct me to where you got that info? I never encountered it, and I am not able to find it in the Ettus docs. Doing proper calibration is important, so we should ensure that the Ettus docs give the correct procedure... Kind regards -- Cédric Hannotier _______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
