David Roberson <[email protected]> wrote:

> *The power of the 20 W pulse is irrelevant. You could probably improve the
> insulation and make it a smaller pulse with less power and less energy.*
> *"*
>
> I realize that this is what you believe, but all the graphs, simulation
> runs, etc. suggest that this may not be correct.
>

You misunderstand. I meant that if this is correct then you have nothing to
worry about regarding the ratios. The ratio of anomalous power to input
power is irrelevant and it can easily be changed.



> How do you explain the fact that the temperature in the vicinity of the
> palladium wire drops very quickly after the pulse?
>

I noticed that. It will take more calibrations to sort out what is going on
there. I do not fully trust that thermocouple. The other thermocouple on
that the electrode is completely wrong. I would like to see what's going on
in the counter-electrode which is also Pd.



> On the other hand I am inserting a component that corresponds to pump
> power leakage which is close to the value that Gigi determined.
>

If this were caused by heat from the pump it would happen during the test
with the pump only. It does not happen. Unless you think the pump output
power varies. I do not think that is likely.

- Jed

Reply via email to