At 01:37 AM 10/11/2011, Horace Heffner wrote: ......
In the section :
NO HEAT TRANSFER TO HEAT EXCHANGER UNTIL
13:22
19:22: "Measured outflow of
primary circuit in heat exchanger, supposedly condensed steam, to be
345 g in 180 seconds, giving a flow of 1.92 g/s. Temperature 23.2
°C."
you're using the flow after it was increased to cool down the
system.
You should use Lewan's 0.9 g/s .. (or the pump's 2ml * 40
strokes/minute = 1.33 g/s)
0.91 * 7800 seconds = 7.1 litres.
This system supposedly has one eCat, while Lewan's Sept version had two
or three, and needed 25 litres to start overflowing, so this data is more
consistent than most that we've seen from October.
- RE: [Vo]:Loo... Mark Iverson-ZeroPoint
- Re: [Vo]:Loo... OrionWorks - Steven V Johnson
- RE: [Vo]:Loo... Robert Leguillon
- RE: [Vo]:Loo... OrionWorks - Steven Vincent Johnson
- Re: [Vo]:Loo... Jed Rothwell
- Re: [Vo]:Loo... Horace Heffner
- Re: [Vo]:Loo... Terry Blanton
- Re: [Vo]:Loo... Horace Heffner
- Re: [Vo]:Loo... Axil Axil
- Re: [Vo]:Loo... Horace Heffner
- [Vo]:Horace ... Alan J Fletcher
- Re: [Vo]:Hor... Horace Heffner
- Re: [Vo]:Loo... Stephen A. Lawrence
- Re: [Vo]:Loo... Joe Catania
- Re: [Vo]:Loo... Joe Catania
- Re: [Vo]:Loo... Joe Catania
- Re: [Vo]:Loo... Joe Catania
- Re: [Vo]:Look at the BIG PICTURE and y... Akira Shirakawa
- RE: [Vo]:Look at the BIG PICTURE ... OrionWorks - Steven Vincent Johnson
- RE: [Vo]:Look at the BIG PICTURE and y... OrionWorks - Steven Vincent Johnson
- Re: [Vo]:Look at the BIG PICTURE ... Akira Shirakawa