If plenty of power is available, and stringent RF interference specs
don't need to be met, the simple wires will work fine.
But I must admit an engineer would always use a coax for such a task.
But maybe not an engineer who is trying to obsfucate
On 5/29/2013 4:47 PM, Arnaud Kodeck wrote:
To bring CB signal, the wires have to be shielded. The impedance must
match in all system. Attenuation of CB signal must be kept as low as
possible ... The simple wires from the black box to the eCat doesn't
meet those requirements. It's common sense for an EE.
------------------------------------------------------------------------
*From:*Axil Axil [mailto:janap...@gmail.com]
*Sent:* mercredi 29 mai 2013 22:43
*To:* vortex-l
*Subject:* Re: EXTERNAL: Re: [Vo]:Speculation about hotCat
Why else would Rossi say that the output of his control box was a
trade secret?
A DC feed of a internal heater is not a trade secret.
On Wed, May 29, 2013 at 4:34 PM, Arnaud Kodeck
<arnaud.kod...@lakoco.be <mailto:arnaud.kod...@lakoco.be>> wrote:
Axil,
I doubt that the actual design of the eCat is able to bring CB range
signal from electrical heating system. Or where else ?
------------------------------------------------------------------------
*From:*Axil Axil [mailto:janap...@gmail.com <mailto:janap...@gmail.com>]
*Sent:* mercredi 29 mai 2013 22:08
*To:* vortex-l
*Subject:* Re: EXTERNAL: Re: [Vo]:Speculation about hotCat
EMF simulation in the CB range will form nanoparticles (aka clusters).
Potassium is the best candidate for the formation of dynamic NAE
through nanoparticle formation when stimulated by EMF.
On Wed, May 29, 2013 at 4:02 PM, Arnaud Kodeck
<arnaud.kod...@lakoco.be <mailto:arnaud.kod...@lakoco.be>> wrote:
Ed,
I think you forget to add the EM stimulation controlled by the black
box between wall socket and the eCat.
Arnaud
