Hello Bill. I have WSJTX CAT configured for the Yaesu FT-2000 now and with split operation set to Rig, It is functioning correctly. So it must be an issue with DXlabs Commander.
73 Jay Jay Hainline KA9CFD Colchester, IL EN40om -----Original Message----- From: Bill Somerville Sent: Monday, September 14, 2015 13:37 To: wsjt-devel@lists.sourceforge.net Subject: Re: [wsjt-devel] CQ Rx bug On 14/09/2015 14:07, Jay Hainline wrote: Hi Jay, > I build WSJTX 1.6.1 r5892 from sourceforge this morning. Using a Yaesu > FT-2000 and DXLabs Commander for CAT. I have 50.280 set in the Working > Frequencies list for JTMSK mode. When I put a checkmark in the box to > activiate the CQ RX 285, the radio goes to 50.285 as it should. But when I > Enable Tx to CQ, the radio stays on 50.285 instead of switching back to > 50.280 on transmit. It makes no difference if I have split operation set > to > none or Rig in the settings and the Rx frequency offset with "CQ nnn..." > is > check marked. Did Commander and your rig go into split mode? As a sanity check can you try the same test with Commander not running and WSJT-X configured to talk directly to your rig please? > > 73 Jay > > Jay Hainline KA9CFD > Colchester, IL EN40om 73 Bill G4WJS. ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
