Hi Bill,
I found another symptom. When I open wsjt-x, the wide graph appears, as I
stated. It turns out that there is also a small “orphan” window that stays
around even after I close the wide graph. The screen shot shows the state of my
screen just after opening wsjt-x. Note the small orphan window just under the
“UTC” label on the main window.
Steve
> On Jun 10, 2016, at 10:18 PM, Steven Franke <[email protected]> wrote:
>
> Hi Bill -
> I experiencing some unusual behavior in r6758. When I open the app after
> having last used MSK144, the wide graph opens instead of the fast graph. This
> is after exiting the program normally with the wide graph closed and the fast
> graph visible.
>
> I’m also seeing different results from the MSK144 decoder (syncmsk144) when
> it is run from wsjt-x and when it is run from the command-line program
> msk144d.f90. This last is my problem - likely an array overrun, as the
> decoder does a bunch of array manipulations, and I have probably made a
> mistake somewhere. I thought that I should mention it on the chance that it
> may have something to do with the first observation.
> Steve
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
