On 30/06/2017 15:37, Jordan Sherer wrote:
Jumping in here since it's sort of relevant to the discussion.
One oddity I found this morning while operating split:
0. I load up WSJTX on 20m
1. I have enabled FT8 mode with rig ctl split
2. VFO is at 14.079.000, transmit offset at 800Hz
3. Tx cycle correctly adjusts split to 14.078.500
4. I move to JT65 on 20m
5. VFO is at 14.076.000, transmit offset at 800Hz
6. Tx cycle incorrectly adjusted the VFO split frequency to 14.078.500
(as if it was still in FT8 mode)
I'm assuming this is probably a just small bug with the split offset
not resetting when switching from FT8 to JT65 in this build. Are you,
or anybody else able to reproduce?
Hi Jordan,
if your Tx DF is 800Hz then your Tx VFO should be at 1kHz below the Rx
VFO, i.e. in this case .078 . If that is not happening then you may have
an issue with your CAT interfacing. Please check the adjustment of your
Tx VFO by CTRL+clicking on the waterfall within each visible 500Hz section.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
