Hi Bill.
This is what happens when I double-click the “Tx” area …
If I then start typing a number, the blue selection is cleared and my numbers
are ignored. [On my system anyway.]
[And yes that’s another truncated pop-up message 😊]
73
Gary ZL2iFB
From: Bill Somerville [mailto:g4...@classdesign.com]
Sent: Tuesday, 27 February 2018 9:01 a.m.
To: wsjt-devel@lists.sourceforge.net
Subject: Re: [wsjt-devel] 1.9 RC2 - UI Suggestion
On 26/02/2018 19:46, g...@isect.com <mailto:g...@isect.com> wrote:
In the same vein, the Tx and Rx frequency setting boxes contain
boilerplate/static text "Tx" or "Rx" and "Hz". If the static text was moved
outside the data-entry box, we could click anywhere in the box and start typing
a new value (e.g. on the numeric keypad), rather than having to double-click
specifically on the value part. It’s a small point, but it will help make it
just a bit easier when we’re in a hurry to catch the DX on FT8!
Same deal with the report box: “Report” should be outside the data-entry box, I
think.
Hi OM (Gary?),
you should be able to double-click anywhere in the spin boxes and type any
valid value (same applies to using the up/down arrows or page up/down to move
in regular intervals), there is no need to click specifically on the numeric
part.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
