Hi Allan I see exactly the same as you with RS232 PTT.
I hadn't monitored the state of the Test PTT button. As you observe, if this turns red during a receive period then the following transmission has no audio. If the button does not turn red during a receive period the following transmission is OK. Watched the behaviour for a number of periods and this seems to be consistent. 73 Charlie G3WDG On Tue, 26 May 2020 at 07:10, Allan VK4QG <[email protected]> wrote: > Gentlemen, > > To start with, my system is a Dell 1650, i7 @3.40 GHz, 16GB RAM, W10 pro > 64bit. I do not use CAT but instead use RTS on COM1 for opto-isolated PTT > and XFR isolation for audio in and out of the sound-card, and have done so > without issue since 2006. > > Two problems : - > > 1. I have found with rc2 that occasionally PTT is not working at all > and when it does there is often no TX audio present either. While > monitoring 'Radio' under 'Settings' I have noticed when this occurs, after > a successful transmission about two seconds into the *RX* period the > 'Test PTT' button turns red and from that point there is no PTT in the > following TX period. After a time it appears to clear itself and PTT in the > following period with or without TX audio. > > 2. I am still getting numerous false decodes. Most of these contain > '/R' and '<.....>'. I am not using AP. > > Many thanks, > > Allan - VK4QG > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel >
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
