Hi Mike and David,
my latest Hamlib patch should sort this out. The issue was a regression,
caused by me, where PTT using RTS or DTR on a serial port, not also used
for CAT, was messed up.
73
Bill
G4WJS.
On 26/05/2020 22:05, Black Michael via wsjt-devel wrote:
Do you have CAT control turned on?
We're still trying to figure out what's causing this.
Mike W9MDB
On Tuesday, May 26, 2020, 03:33:25 AM CDT, David M. Boyter
<[email protected]> wrote:
Morning
I get the same as I use 232 for PTT. Happened about every 2nd transmission
And "tune" button same problem
73
David AE5SB
------------------------------------------------------------------------
*From:* Charles Suckling <[email protected]>
*Sent:* Tuesday, May 26, 2020 1:35 AM
*To:* WSJT software development <[email protected]>
*Subject:* Re: [wsjt-devel] WSJT-X 2.2.0 rc2
Hi Allan
I see exactly the same as you with RS232 PTT.
I hadn't monitored the state of the Test PTT button. As you observe,
if this turns red during a receive period then the following
transmission has no audio. If the button does not turn red during a
receive period the following transmission is OK. Watched the
behaviour for a number of periods and this seems to be consistent.
73
Charlie G3WDG
On Tue, 26 May 2020 at 07:10, Allan VK4QG <[email protected]
<mailto:[email protected]>> wrote:
Gentlemen,
To start with, my system is a Dell 1650, i7 @3.40 GHz, 16GB RAM,
W10 pro 64bit. I do not use CAT but instead use RTS on COM1 for
opto-isolated PTT and XFR isolation for audio in and out of the
sound-card, and have done so without issue since 2006.
Two problems : -
1. I have found with rc2 that occasionally PTT is not working
at all and when it does there is often no TX audio present either.
While monitoring 'Radio' under 'Settings' I have noticed when this
occurs, after a successful transmission about two seconds into the
_RX_ period the 'Test PTT' button turns red and from that point
there is no PTT in the following TX period. After a time it
appears to clear itself and PTT in the following period with or
without TX audio.
2. I am still getting numerous false decodes. Most of these
contain '/R' and '<.....>'. I am not using AP.
Many thanks,
Allan - VK4QG
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
