Hi David,
no, that is a different issue. I believe recent Hamlib changes may have
addressed that one too. I will contact you off list if you wish to try
out a test version of WSJT-X.
73
Bill
G4WJS.
On 27/05/2020 14:13, K2DBK-WSJT wrote:
Hi Bill,
I know this was addressed to the other David, but will this resolve
the issue I (and others) have run into using Split (rather than Fake It)?
73,
David, K2DBK
*From:* Bill Somerville <[email protected]>
*Sent:* Tuesday, May 26, 2020 5:10 PM
*To:* [email protected]
*Subject:* Re: [wsjt-devel] WSJT-X 2.2.0 rc2
Hi Mike and David,
my latest Hamlib patch should sort this out. The issue was a
regression, caused by me, where PTT using RTS or DTR on a serial port,
not also used for CAT, was messed up.
73
Bill
G4WJS.
On 26/05/2020 22:05, Black Michael via wsjt-devel wrote:
Do you have CAT control turned on?
We're still trying to figure out what's causing this.
Mike W9MDB
On Tuesday, May 26, 2020, 03:33:25 AM CDT, David M. Boyter
<[email protected]> <mailto:[email protected]> wrote:
Morning
I get the same as I use 232 for PTT. Happened about every 2nd
transmission
And "tune" button same problem
73
David AE5SB
------------------------------------------------------------------------
*From:*Charles Suckling <[email protected]> <mailto:[email protected]>
*Sent:* Tuesday, May 26, 2020 1:35 AM
*To:* WSJT software development <[email protected]>
<mailto:[email protected]>
*Subject:* Re: [wsjt-devel] WSJT-X 2.2.0 rc2
Hi Allan
I see exactly the same as you with RS232 PTT.
I hadn't monitored the state of the Test PTT button. As you
observe, if this turns red during a receive period then the
following transmission has no audio. If the button does not turn
red during a receive period the following transmission is OK.
Watched the behaviour for a number of periods and this seems to be
consistent.
73
Charlie G3WDG
On Tue, 26 May 2020 at 07:10, Allan VK4QG <[email protected]
<mailto:[email protected]>> wrote:
Gentlemen,
To start with, my system is a Dell 1650, i7 @3.40 GHz, 16GB
RAM, W10 pro 64bit. I do not use CAT but instead use RTS on
COM1 for opto-isolated PTT and XFR isolation for audio in and
out of the sound-card, and have done so without issue since 2006.
Two problems : -
1. I have found with rc2 that occasionally PTT is not
working at all and when it does there is often no TX audio
present either. While monitoring 'Radio' under 'Settings' I
have noticed when this occurs, after a successful transmission
about two seconds into the _RX_ period the 'Test PTT' button
turns red and from that point there is no PTT in the following
TX period. After a time it appears to clear itself and PTT in
the following period with or without TX audio.
2. I am still getting numerous false decodes. Most of
these contain '/R' and '<.....>'. I am not using AP.
Many thanks,
Allan - VK4QG
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
