So I actually need a device which would ACCEPT the dialtone/ring and
that would go on the Page Tip/Page Ring contacts. Any Idea what UNA
Ringing is? Googling just returns a bunch of Spanish results. Would
that broadcast the phone ringing sound over the PA? So connect a normal
FXS Port to that?
On 12/23/2020 2:34 PM, Chuck McCown wrote:
If you configure an ATA that will actually draw dial tone from a POTS
line, then it will work with this paging adapter. I think that would
be an FXS config. FXO would give you dial tone from the ATA. Been a
very long time since I use the linksys/cisco spa products to extend
dial tone over the internet, but they seemed to work fine.
*From:* Daniel White
*Sent:* Wednesday, December 23, 2020 1:23 PM
*To:* AnimalFarm Microwave Users Group ; Nate Burke
*Subject:* Re: [AFMUG] Old Phone Question
Algo (https://www.algosolutions.com/) and CyberData
(https://www.cyberdata.net/collections/sip) are the go to brands for
paging equipment that is SIP compatible along with adapters. Viking
Electronics (https://www.vikingelectronics.com/) does make a number of
items that make it easy to work with old paging systems. I didn't
look at the manual, but the RAD-1A
(https://www.vikingelectronics.com//products/rad-1a/) from Viking is
probably what you are looking for paired with an ATA.
Depending on the layout and configuration of what you are working with
you can do certain things with a standard ATA (usually just FXS ports)
and certain things with an ATA with an FXO port (these usually have
FXS ports as well).
As far as Atheral goes... I won't support trying to jury rig an ATA
into these situations typically just because they can be finicky and I
can't see how someone is installing something. Although some ATA
manufacturers have different terms for configurations that should do
what you want, in my experience they typically don't behave the way
I'd expect. Algo, CyberData, and Viking make all of this stuff simple
so it is just better to go that route.
photograph
Daniel White
Co-Founder
phone:+1 (702) 470-2770
direct:+1 (702) 470-2766
Nate Burke
December 22, 2020 at 17:02
So I'm not saying it's old.... but this was put in when I was still
in High School
Valcom V-2001 paging system. I'm looking to convert the driving
phone system over to VoIP.
I've found the manual here. https://www.valcom.com/pdf/v-2001.pdf
It references terms I'm not familiar with. It says 'Compatible with
Any Electronic Key or PABX' Does that mean that I can use an ATA to
plug into it? Or is this something special?
There are currently wires hooked up to contacts labeled 'Page
Tip/Page Ring' And 'UNA Ringing' (2 wires) I"m guessing Page
Tip/ring are the 2 wires that would run to the ATA, but what is UNA
Ringing?
Anybody hooked one of these up to an ATA before?
------------------------------------------------------------------------
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com