broomstick in a step ladder or mast between the back doors of the van if the douchebag tech pulled the standsd out and didnt put it back
On Fri, Jan 23, 2015 at 4:29 PM, Jaime Solorza <losguyswirel...@gmail.com> wrote: > We made a stand from unistrut and pipe. Adjustable for different size > spools ...from LMR 400 to large Heliax spools. We used earth anchors to > keep it from falling. We also had wooden ones for 1000 ft rolls of guyed > wire...electrical houses carry the attachments and bracelets for C channel/ > unistrut > > Jaime Solorza > On Jan 23, 2015 3:13 PM, "Caleb Knauer" <cknauer.li...@gmail.com> wrote: > >> Any suggestions for a cable reel stand for spooling cable/coax out on >> a tower run? Our improvised methods need updating, and my google-fu >> is weak and I'm only finding either junk or stuff that's waaaaay too >> expensive. Think a pair of jack stands with a rod between them but >> nicer and with less falling over. >> > -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925