Use a Conduit in the corner of the fenced area 'if the douchebag tech pulled the standsd out and didnt put it back"
Erich Kaiser North Central Tower Consulting [email protected] Office: 630-621-4804 Cell: 630-777-9291 On Fri, Jan 23, 2015 at 4:42 PM, Josh Luthman <[email protected]> wrote: > That works too, but not too well. > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > On Jan 23, 2015 5:41 PM, "That One Guy" <[email protected]> wrote: > >> broomstick in a step ladder or mast between the back doors of the van if >> the douchebag tech pulled the standsd out and didnt put it back >> >> >> On Fri, Jan 23, 2015 at 4:29 PM, Jaime Solorza <[email protected] >> > wrote: >> >>> We made a stand from unistrut and pipe. Adjustable for different size >>> spools ...from LMR 400 to large Heliax spools. We used earth anchors to >>> keep it from falling. We also had wooden ones for 1000 ft rolls of guyed >>> wire...electrical houses carry the attachments and bracelets for C channel/ >>> unistrut >>> >>> Jaime Solorza >>> On Jan 23, 2015 3:13 PM, "Caleb Knauer" <[email protected]> wrote: >>> >>>> Any suggestions for a cable reel stand for spooling cable/coax out on >>>> a tower run? Our improvised methods need updating, and my google-fu >>>> is weak and I'm only finding either junk or stuff that's waaaaay too >>>> expensive. Think a pair of jack stands with a rod between them but >>>> nicer and with less falling over. >>>> >>> >> >> >> -- >> All parts should go together without forcing. You must remember that the >> parts you are reassembling were disassembled by you. Therefore, if you >> can't get them together again, there must be a reason. By all means, do not >> use a hammer. -- IBM maintenance manual, 1925 >> >
