That works too, but not too well. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Jan 23, 2015 5:41 PM, "That One Guy" <thatoneguyst...@gmail.com> wrote:
> broomstick in a step ladder or mast between the back doors of the van if > the douchebag tech pulled the standsd out and didnt put it back > > > On Fri, Jan 23, 2015 at 4:29 PM, Jaime Solorza <losguyswirel...@gmail.com> > wrote: > >> We made a stand from unistrut and pipe. Adjustable for different size >> spools ...from LMR 400 to large Heliax spools. We used earth anchors to >> keep it from falling. We also had wooden ones for 1000 ft rolls of guyed >> wire...electrical houses carry the attachments and bracelets for C channel/ >> unistrut >> >> Jaime Solorza >> On Jan 23, 2015 3:13 PM, "Caleb Knauer" <cknauer.li...@gmail.com> wrote: >> >>> Any suggestions for a cable reel stand for spooling cable/coax out on >>> a tower run? Our improvised methods need updating, and my google-fu >>> is weak and I'm only finding either junk or stuff that's waaaaay too >>> expensive. Think a pair of jack stands with a rod between them but >>> nicer and with less falling over. >>> >> > > > -- > All parts should go together without forcing. You must remember that the > parts you are reassembling were disassembled by you. Therefore, if you > can't get them together again, there must be a reason. By all means, do not > use a hammer. -- IBM maintenance manual, 1925 >
