Rack-a-tier. Super portable.
On Wed, Jan 28, 2015 at 7:38 AM, Caleb Knauer <[email protected]> wrote: > This is what I have been looking at. A recent crew we contracted had a > perfect setup but I didn't think to ask what they were, doh. > > On Fri, Jan 23, 2015 at 9:47 PM, David Milholen <[email protected]> > wrote: > >> Found these just looking around >> >> http://www.toolfetch.com/sumner-780941-no-60-screw-type-telescoping-reel-jack-for-26-to-56-diameter-reels.html?utm_source=google&utm_medium=cse&utm_term=780941&gclid=CN62gI_Oq8MCFQwaaQodUFwAsw >> >> These are very similar or same ones I see the verizon pro guys use when >> working a site. >> Very versatile with respect of the pipe used to go between them. >> >> On 1/23/2015 4:42 PM, Josh Luthman wrote: >> >> That works too, but not too well. >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> On Jan 23, 2015 5:41 PM, "That One Guy" <[email protected]> >> wrote: >> >>> broomstick in a step ladder or mast between the back doors of the van if >>> the douchebag tech pulled the standsd out and didnt put it back >>> >>> >>> On Fri, Jan 23, 2015 at 4:29 PM, Jaime Solorza < >>> [email protected]> wrote: >>> >>>> We made a stand from unistrut and pipe. Adjustable for different size >>>> spools ...from LMR 400 to large Heliax spools. We used earth anchors to >>>> keep it from falling. We also had wooden ones for 1000 ft rolls of guyed >>>> wire...electrical houses carry the attachments and bracelets for C channel/ >>>> unistrut >>>> >>>> Jaime Solorza >>>> On Jan 23, 2015 3:13 PM, "Caleb Knauer" <[email protected]> >>>> wrote: >>>> >>>>> Any suggestions for a cable reel stand for spooling cable/coax out on >>>>> a tower run? Our improvised methods need updating, and my google-fu >>>>> is weak and I'm only finding either junk or stuff that's waaaaay too >>>>> expensive. Think a pair of jack stands with a rod between them but >>>>> nicer and with less falling over. >>>>> >>>> >>> >>> >>> -- >>> All parts should go together without forcing. You must remember that >>> the parts you are reassembling were disassembled by you. Therefore, if you >>> can't get them together again, there must be a reason. By all means, do not >>> use a hammer. -- IBM maintenance manual, 1925 >>> >> >> -- >> > > -- -- *Sam Lambie* Taosnet Wireless Tech. 575-758-7598 Office www.Taosnet.com <http://www.newmex.com>
