Even if I'm seeing full speeds in UDP? I checked both radios and both routers and they all say 1gbps full duplex
On Fri, Jul 17, 2015 at 9:10 PM, Butch Evans <but...@butchevans.com> wrote: > On Fri, 2015-07-17 at 22:23 +0000, TJ Trout wrote: > > I have a set of Mimosa radios that when installed 3 weeks ago > > reported 500mbps mac rate and that was confirmed with the radios > > internal speed test as well as btest between two CCR's in both TCP > > and UDP, everything was great until I upgraded to beta software and I > > started seeing a problem where the radios Phy/Mac/Speed test are all > > the same as prior but when doing btest between two CCR's I can get > > 500 udp but only about 5-40 tcp! > > > > I promptly downgraded software and I'm still seeing the same problem. > > > > Any ideas? > > The most common cause of this sort of symptom is a speed/duplex > mismatch on an ethernet port. Check them all (both sides of each link) > until you verify this is not the issue. > > -- > Butch Evans > Training and Support for WISPs > 702-537-0979 > http://store.wispgear.net/ > http://www.butchevans.com/ >