lol, if only that were true On Fri, May 20, 2016 at 6:13 PM, Eric Kuhnke <[email protected]> wrote:
> keystone is keystone, no? it's an open standard. all same dimension to > click into the faceplate. > > more detailed dimensions here, for example, > http://www.delock.de/infothek/Kataloge_Flyer/EN137708_213.pdf > > > > On Fri, May 20, 2016 at 4:11 PM, That One Guy /sarcasm < > [email protected]> wrote: > >> without buying one to physically check would there be a way to know if >> our leviton keystones fit that >> >> On Fri, May 20, 2016 at 5:49 PM, Eric Kuhnke <[email protected]> >> wrote: >> >>> If it has to be under $200 or near it with no holes, you drill them out >>> yourself and install glands/conduit, this: >>> >>> >>> http://www.l-com.com/nema-enclosures-18x16x8-inch-weatherproof-nema-enclosure-with-mounting-plate >>> >>> consider doing it as two surface mounted 12-port keystone patch panels >>> on the aluminum backplate, rather than a 1U 24-port patch panel. >>> >>> such as, >>> http://www.showmecables.com/product/Keystone-Blank-Patch-Panel-High-Density-Style-12-Port.aspx >>> >>> >>> >>> >>> >>> On Fri, May 20, 2016 at 3:38 PM, That One Guy /sarcasm < >>> [email protected]> wrote: >>> >>>> I need a small enclosure to house a 1u 24 port patch panel (we normally >>>> sick 3U minimum in a box) >>>> this will need to allow for up to 48 cable entries if the whole thing >>>> were populated. This is for the top of a grain elevator (will use the same >>>> set up elsewhere) >>>> >>>> We bring BBDGE up to it and terminate to the panel, then as we add >>>> radios we just add the tail, we will bond the copper shields in here too. >>>> We do individual 1/2 inch knockout entries. >>>> >>>> It just needs to stand up in wind and sun, we will put all the holes in >>>> it. I do meed to keep the weight down because it will probably end up >>>> mounted to the site 1 1/2 inch conduit >>>> >>>> Im looking for inexpensive (sub 200$) no removable gaskets for techs to >>>> drop part numbers. I know all the vendors websites, Im looking for >>>> something somebody else has used. It doesnt even have to be this same >>>> design, just a cross connect box that we can change the top end tails >>>> easily. need part numbers here >>>> >>>> >>>> >>>> -- >>>> If you only see yourself as part of the team but you don't see your >>>> team as part of yourself you have already failed as part of the team. >>>> >>> >>> >> >> >> -- >> If you only see yourself as part of the team but you don't see your team >> as part of yourself you have already failed as part of the team. >> > > -- If you only see yourself as part of the team but you don't see your team as part of yourself you have already failed as part of the team.
