+1 There are many "keystone jacks" of various dimensions On May 20, 2016 6:51 PM, "That One Guy /sarcasm" <[email protected]> wrote:
> lol, if only that were true > > On Fri, May 20, 2016 at 6:13 PM, Eric Kuhnke <[email protected]> > wrote: > >> keystone is keystone, no? it's an open standard. all same dimension to >> click into the faceplate. >> >> more detailed dimensions here, for example, >> http://www.delock.de/infothek/Kataloge_Flyer/EN137708_213.pdf >> >> >> >> On Fri, May 20, 2016 at 4:11 PM, That One Guy /sarcasm < >> [email protected]> wrote: >> >>> without buying one to physically check would there be a way to know if >>> our leviton keystones fit that >>> >>> On Fri, May 20, 2016 at 5:49 PM, Eric Kuhnke <[email protected]> >>> wrote: >>> >>>> If it has to be under $200 or near it with no holes, you drill them out >>>> yourself and install glands/conduit, this: >>>> >>>> >>>> http://www.l-com.com/nema-enclosures-18x16x8-inch-weatherproof-nema-enclosure-with-mounting-plate >>>> >>>> consider doing it as two surface mounted 12-port keystone patch panels >>>> on the aluminum backplate, rather than a 1U 24-port patch panel. >>>> >>>> such as, >>>> http://www.showmecables.com/product/Keystone-Blank-Patch-Panel-High-Density-Style-12-Port.aspx >>>> >>>> >>>> >>>> >>>> >>>> On Fri, May 20, 2016 at 3:38 PM, That One Guy /sarcasm < >>>> [email protected]> wrote: >>>> >>>>> I need a small enclosure to house a 1u 24 port patch panel (we >>>>> normally sick 3U minimum in a box) >>>>> this will need to allow for up to 48 cable entries if the whole thing >>>>> were populated. This is for the top of a grain elevator (will use the same >>>>> set up elsewhere) >>>>> >>>>> We bring BBDGE up to it and terminate to the panel, then as we add >>>>> radios we just add the tail, we will bond the copper shields in here too. >>>>> We do individual 1/2 inch knockout entries. >>>>> >>>>> It just needs to stand up in wind and sun, we will put all the holes >>>>> in it. I do meed to keep the weight down because it will probably end up >>>>> mounted to the site 1 1/2 inch conduit >>>>> >>>>> Im looking for inexpensive (sub 200$) no removable gaskets for techs >>>>> to drop part numbers. I know all the vendors websites, Im looking for >>>>> something somebody else has used. It doesnt even have to be this same >>>>> design, just a cross connect box that we can change the top end tails >>>>> easily. need part numbers here >>>>> >>>>> >>>>> >>>>> -- >>>>> If you only see yourself as part of the team but you don't see your >>>>> team as part of yourself you have already failed as part of the team. >>>>> >>>> >>>> >>> >>> >>> -- >>> If you only see yourself as part of the team but you don't see your team >>> as part of yourself you have already failed as part of the team. >>> >> >> > > > -- > If you only see yourself as part of the team but you don't see your team > as part of yourself you have already failed as part of the team. >
