Btw a good way to make removable gaskets non removable is to pre silicone them to the lid.. On May 20, 2016 5:39 PM, "That One Guy /sarcasm" <thatoneguyst...@gmail.com> wrote:
> I need a small enclosure to house a 1u 24 port patch panel (we normally > sick 3U minimum in a box) > this will need to allow for up to 48 cable entries if the whole thing were > populated. This is for the top of a grain elevator (will use the same set > up elsewhere) > > We bring BBDGE up to it and terminate to the panel, then as we add radios > we just add the tail, we will bond the copper shields in here too. We do > individual 1/2 inch knockout entries. > > It just needs to stand up in wind and sun, we will put all the holes in > it. I do meed to keep the weight down because it will probably end up > mounted to the site 1 1/2 inch conduit > > Im looking for inexpensive (sub 200$) no removable gaskets for techs to > drop part numbers. I know all the vendors websites, Im looking for > something somebody else has used. It doesnt even have to be this same > design, just a cross connect box that we can change the top end tails > easily. need part numbers here > > > > -- > If you only see yourself as part of the team but you don't see your team > as part of yourself you have already failed as part of the team. >