hopefully the SAF guys will get me a CLI or something to just configure the port at 1000. Anybody know why this is, Its like this on powercode BMUs also, you can only select up to 100 on the gigabit ports. I seem to recall reading something sometime back about that being somewhat common
On Wed, Jul 19, 2017 at 2:51 PM, Chuck McCown <[email protected]> wrote: > All surge suppressors can and probably will cause this if there is a > ground potential difference or an unusually high amount of electrical noise > on the ground that the surge suppressor is connected to. > > Lift the ground off the surge suppressor to see if that helps. > > *From:* Steve Jones > *Sent:* Wednesday, July 19, 2017 1:49 PM > *To:* [email protected] > *Subject:* Re: [AFMUG] flapping ethernet port ospf workaround > > BBDGE > its got the transtector surge suppressor, I'm suspecting that, this is the > only lik with it and both radios are doing it > > On Wed, Jul 19, 2017 at 2:44 PM, Colin Stanners <[email protected]> > wrote: > >> Do you have shielded cable the whole way end to end? SAFs seem to be >> quite sensitive to that. >> >> On Jul 19, 2017 11:20 AM, "Steve Jones" <[email protected]> >> wrote: >> >>> So ive been dealing with the SAFs and the mikrotiks being uppity with >>> one another. >>> SAF has a gigabit port, but it only offers the option to lock it to 100, >>> not gigabit. >>> so I have the mikrotiks set, just not the otherside, the port still >>> flaps on both radios >>> >>> what was happening is everytime it flaps, the interface dropped in ospf >>> and went neighbor down, rerouting traffic then coming back up >>> >>> what I did was made a bridge, added that port to it, and put the ospf ip >>> on the bridge itself, this allows the port to flap without the ospf >>> interface going down until we work throught the issue with SAF >>> >>> I'm wondering if this is causing some other harm having it on the >>> bridge, rather than the physical port >>> >> >
