On 07/18/2014 11:39 AM, Gene Heskett wrote:
On Friday 18 July 2014 10:50:47 John Hein did opine
And Gene did reply:
Gene Heskett wrote at 10:26 -0400 on Jul 18, 2014:
> Trying to figure out why amanda can't backup this machine, one of
> the things I noticed in /etc, is that on the shop box, which works,
> there is not an /etc/xinetd.d but it has an old-xinetd.d with a
> single stanza amanda file in it.
>
> An ls -lau shows that file, /etc/old-xinetd.d/amanda was apparently
> accessed a few minutes ago by my amcheck from the server.
>
> However, on the new install on the machine that is failing to allow
> the connection, there is an /etc/xinet.d, with an amanda file in it
> with an old last access date/time, was not 'touched' when I ran the
> amcheck. Its last access date/time is I believe, the date/time of
> the installation itself.
>
> That amanda-common is 2.6.1p1 IIRC.
>
> amcheck says:
> WARNING: lathe: selfcheck request failed: Connection refused
Try running xinetd -d (then amcheck) to see if (or why not) xinetd is
running amandad.
Puzzle, first I had to install it! Then got a report ending here:
Service defaults
Bind = All addresses.
Only from: All sites
No access: No blocked sites
No logging
Service configuration: amanda
id = amanda
flags = IPv4
socket_type = dgram
Protocol (name,number) = (udp,17)
port = 10080
wait = yes
user = 34
group = 34
Groups = yes
PER_SOURCE = -1
Bind = All addresses.
Server = /usr/lib/amanda/amandad
Server argv = amandad -auth=bsd amdump amindexd amidxtaped
Only from: All sites
No access: No blocked sites
No logging
14/7/18@11:27:40: DEBUG: 3748 {cnf_start_services} Started service: amanda
14/7/18@11:27:40: DEBUG: 3748 {cnf_start_services} mask_max = 6,
services_started = 1
14/7/18@11:27:40: NOTICE: 3748 {main} xinetd Version 2.3.14 started with
libwrap loadavg options compiled in.
14/7/18@11:27:40: NOTICE: 3748 {main} Started working: 1 available service
14/7/18@11:27:40: DEBUG: 3748 {main_loop} active_services = 1
But running an amcheck on the server didn't get any further output than
what you see above. And got the same results, connection refused.
But I see an auth=bsd, where it should be bsdtcp. Fixed that, restarted
xinetd, no change in amcheck report, lathe still refused connection. the
amanda file in xinetd.d wasn't touched. So we are a bit closer, but no
biscuit. Next?
If you are using bsdtcp, then you must fix the xinetd file for it.
socket_type = stream
protocol = tcp
wait = no
