Hello all,

I'm new to this project and would greatly appreciate a couple of pointers on how to get the serial port console working on the x50v.  I got the penguin to display itself and the thermometer in the graphic to rise (freezes after the penguin eyes go all funny).  But, I can't seem to get any output from the serial cable.   When I scope out the Serial TX pin on the my Dell I seem to get a partial initialization of the port because It changes state from a 0 to a 1 right after starting Haret and then pressing run. Linux never actually boots.  I'm just hoping to get some more info to make it easier to debug what is actually happening.

I've built the serial cable that fisher had so kindly documented.  Although in the documentation, I do suspect that the pin outs for Dell pin number 10-Rx(dell in) and 11-TX(dell out) are reversed on the practical serial cable making method; I think it should be 11-Rx, 10-TX. if someone has a cable handy could they double check this for me?  Fisherss am I correct?  For now I just hook a scope probe up to both the pins (10 and 11) and try to make data come out of either or.

Did you have to modify the haret program to get the serial port of the dell up and running?  Or will just modifying General Purpose I/O Alternate Function Select Registers by adding the appropriate info the default.txt file work just fine (set GAFR(34) 1  and so on)

I Hope that makes sense... any help would be greatly appreciated...

Regards..

Mark

-- 
_______________________________________________
Aximx50-port mailing list
[email protected]
https://www.handhelds.org/mailman/listinfo/aximx50-port

Reply via email to