A few things:
1. you must be using fisherss' haret, as it initializes the serial port
2. here is my default.txt:
print "Setting GPIOs for serial port..."
set GAFR(34) 1
set GAFR(35) 1
set GAFR(37) 1
set GAFR(39) 2
set GAFR(40) 2
set GAFR(41) 2
set GPDR(34) 0
set GPDR(35) 0
set GPDR(37) 0
set GPLR(34) 1
set GPLR(35) 1
set GPLR(37) 1
set GPLR(39) 1
set kernel "zImage"
set initrd "initrd"
set mtype 740
set cmdline "root=/dev/ram0 rw ramdisk_size=16384 keepinitrd
init=/linuxrc console=tty0 console=ttyS0,115200n8"
boot
this works for me.
When you wire up the serial cable, the pin that reads +- 3v with ground
on a voltmeter is the tx pin from the x50 itself. it should be labeled
which pin this should go to on the max232 chip. On the pc side, it's
+9v, and the +9v from the max232 that comes from the max232 should go to
the RX pin on your computer.
Similarly, the +9v from your computer rs232 cable is the tx from the
computer, and should go through the max232 to the rx on the other side.
if you aren't using fisherss' haret, however, it probably won't work,
because his haret is modified to initialize the serial port.
Richard
Mark Co-Dyre wrote:
Hello all,
I'm new to this project and would greatly appreciate a couple of
pointers on how to get the serial port console working on the x50v. I
got the penguin to display itself and the thermometer in the graphic
to rise (freezes after the penguin eyes go all funny). But, I can't
seem to get any output from the serial cable. When I scope out the
Serial TX pin on the my Dell I seem to get a partial initialization of
the port because It changes state from a 0 to a 1 right after starting
Haret and then pressing run. Linux never actually boots. I'm just
hoping to get some more info to make it easier to debug what is
actually happening.
I've built the serial cable that fisher had so kindly documented.
Although in the documentation, I do suspect that the pin outs for Dell
pin number 10-Rx(dell in) and 11-TX(dell out) are reversed on the
practical serial cable making method; I think it should be 11-Rx,
10-TX. if someone has a cable handy could they double check this for
me? Fisherss am I correct? For now I just hook a scope probe up to
both the pins (10 and 11) and try to make data come out of either or.
Did you have to modify the haret program to get the serial port of the
dell up and running? Or will just modifying General Purpose I/O
Alternate Function Select Registers by adding the appropriate info the
default.txt file work just fine (set GAFR(34) 1 and so on)
I Hope that makes sense... any help would be greatly appreciated...
Regards..
Mark
--
_______________________________________________
Aximx50-port mailing list
[email protected]
https://www.handhelds.org/mailman/listinfo/aximx50-port