OK... I'm following the doc for 1.1.x. What doc did you use for your
cluster setup?
On 03/19/2013 03:14 PM, Jeremy McSpadden wrote:
Scanning nodes/initialize do not work in 1.x.
--
Jeremy McSpadden
Flux Labs, Inc | http://www.fluxlabs.net <http://www.fluxlabs.net/> |
Endless Solutions
Office : 850-250-5590x101 <tel:850-250-5590;101> | Cell : 850-890-2543
<tel:850-890-2543> | Fax : 850-254-2955 <tel:850-254-2955>
On Mar 19, 2013, at 3:09 PM, "Raymond Norton" <[email protected]
<mailto:[email protected]>> wrote:
In my 1.1 set up I ran baruwa-admin initconfig and got a message the
scanner was initialized, yet via the gui I get a message to
initialize the scanner again. When I select "Initialize" , I get
conflicting messages: One says its initialized and another message
under it says to initialize the scanner??
Scanner works fine otherwise.
--
Raymond Norton
LCTN
952.955.7766
_______________________________________________
Keep Baruwa FREE - http://pledgie.com/campaigns/12056
--
This message has been scanned for viruses and
dangerous content by *MailScanner* <http://www.mailscanner.info/>, and is
believed to be clean.
_______________________________________________
Keep Baruwa FREE - http://pledgie.com/campaigns/12056
--
Raymond Norton
LCTN
952.955.7766
_______________________________________________
Keep Baruwa FREE - http://pledgie.com/campaigns/12056
