Can anyone explain why I am not seeing the loopback as my ospf router-id? I
know I can set it manually, just trying to understand what is going on. I have
cleared the ip ospf proc more than once. Any ideas?
R5#sh ip protocols
Routing Protocol is "ospf 9"
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Router ID 100.5.6.5
It is an area border router
Number of areas in this router is 2. 2 normal 0 stub 0 nssa
Maximum path: 4
Routing for Networks:
Routing on Interfaces Configured Explicitly (Area 0):
Loopback0
Serial0/0/0.2
GigabitEthernet0/0.15
Routing on Interfaces Configured Explicitly (Area 56):
Serial0/0/0.1
Reference bandwidth unit is 100 mbps
Routing Information Sources:
Gateway Distance Last Update
100.5.6.6 110 00:39:28
100.100.100.6 110 00:02:38
100.100.100.1 110 00:02:38
100.100.100.2 110 00:02:38
Distance: (default is 110)
R5#show ip int bri | ex un
Interface IP-Address OK? Method Status
Protocol
GigabitEthernet0/0.15 100.1.5.5 YES manual up up
Serial0/0/0.1 100.2.5.5 YES manual up up
Serial0/0/0.2 100.5.6.5 YES manual up up
Loopback0 100.100.100.5 YES manual up up
running: c3845-adventerprisek9-mz.124-24.T5.bin
Thanks, Fulvio
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
http://onlinestudylist.com/mailman/listinfo/ccie_rs
