Sorry I didnt check well, had some variance and delay configs. On 10 August 2012 00:39, Keller Giacomarro <[email protected]> wrote:
> Good thought on variance, but I do not have it configured. > > R3(config-router)#do show ver | inc 12.4 > Cisco IOS Software, C2600 Software (C2600-ADVENTERPRISEK9-M), Version > 12.4(15)T14, RELEASE SOFTWARE (fc2) > R3(config-router)#do show run | inc variance > R3(config-router)# > > I'm also pretty sure it's not an artifact from my setup, as the output > I pasted was directly out of the solution guide! > > Keller Giacomarro > [email protected] > > > On Fri, Aug 10, 2012 at 2:35 AM, [email protected] > <[email protected]> wrote: > > Hi Keller, > > Which IOS version are you using? > > Just tested in 12.4T, I only see feasible successor when I use the below > > command. > > I would guess you have variance configured under eigrp. > > > > /Aliou > > > > On 10 August 2012 00:07, Keller Giacomarro <[email protected]> wrote: > >> > >> Okay, pretty stumped here. > >> > >> R3#show ip eigrp topology 150.1.7.0 255.255.255.0 > >> IP-EIGRP (AS 100): Topology entry for 150.1.7.0/24 > >> State is Passive, Query origin flag is 1, 1 Successor(s), FD is 128256 > >> Routing Descriptor Blocks: > >> 155.1.37.7 (FastEthernet0/0), from 155.1.37.7, Send flag is 0x0 > >> Composite metric is (128256/128000), Route is Internal > >> Vector metric: > >> Minimum bandwidth is 100000 Kbit > >> Total delay is 5010 microseconds > >> Reliability is 255/255 > >> Load is 1/255 > >> Minimum MTU is 1500 > >> Hop count is 1 > >> 155.1.0.5 (Serial1/0.1), from 155.1.0.5, Send flag is 0x0 > >> Composite metric is (1152512/640512), Route is Internal > >> Vector metric: > >> Minimum bandwidth is 128 Kbit > >> Total delay is 45020 microseconds > >> Reliability is 255/255 > >> Load is 1/255 > >> > >> I thought that 'show ip eigrp topo x.x.x.x/x' showed successors and > >> feasible successors only. But the second entry above shows an AD of > >> 640512, which is larger than the FD of 128256. Is this considered a > >> Feasible Successor or not? If not, what's it doing in this command > >> output? > >> > >> Thanks as always! > >> > >> Keller Giacomarro > >> [email protected] > >> > >> > >> Blogs and organic groups at http://www.ccie.net > >> > >> _______________________________________________________________________ > >> Subscription information may be found at: > >> http://www.groupstudy.com/list/CCIELab.html > >> > >> > >> > >> > >> > >> > >> > > > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
