Hey Bro,
I ran into an issue similar to that before but mine was because there
was no phone connected to the port.
Antonio
Quoting Matthew Berry <ciscovoiceg...@gmail.com>:
I see this issue from time to time. The VLAN interfaces on my BR1-RTR
show a state of up, but line protocol is down.
I made sure that there are ports with the vlans configured. I reload
the router. I also made sure the vlans were in existence.
At this point, my BR1-RTR is useless until I get this working. Any ideas?
interface Vlan130
ip address 10.10.101.1 255.255.255.0
!
interface Vlan240
ip address 10.10.201.1 255.255.255.0
...
interface FastEthernet1/1
switchport trunk native vlan 130
switchport mode trunk
switchport voice vlan 240
====
BR1-RTR#show vlan-switch br
VLAN Name Status Ports
---- -------------------------------- ---------
-------------------------------
...
130 DATA active Fa1/1, Fa1/15
240 PHONES active Fa1/1, Fa1/2, Fa1/3, Fa1/4
Fa1/5, Fa1/6, Fa1/7, Fa1/8
Fa1/9, Fa1/10, Fa1/11, Fa1/12
Fa1/13, Fa1/14, Fa1/15
====
BR1-RTR#show ip int bri
Interface IP-Address OK? Method Status
Protocol
...
Vlan130 10.10.101.1 YES manual up
down
Vlan240 10.10.201.1 YES NVRAM up
down
--
*Matthew Berry*
/A+, CCENT, CCNA, CCNA Voice, CCVP, CCIE Voice Written/
*_Vitals:_*
*GVoice: *+1.612.424.5044
*Gmail*: ciscovoiceg...@gmail.com
*Skype*: ciscovoiceguru
*Twitter*: ciscovoiceguru
*_Cert Stats:_*
Cisco Cert Journey Began: Jan 1, 2009
1st Lab Attempt: Aug 16, 2010
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
