Hello everyone
I need your help to identify an issue on my Diablo Model 40 Series. I
don't know where to look, it's so vast !
Here's the problem:
When RUN is activated, the drive begins its spin up and simultaneously
deploys the heads (normal) but instead of stabilizing them, the Head
Positioner receives a burst of reverse/forward micro signals. The heads
"vibrate", this creates an audible frequency "BRRRRRRRRRRRRRRRRRR", and
it is infinite, the heads are never loaded and the drive never reaches
READY.
At first I thought that perhaps the track zero sensor was defective or
something of the same order but when I disengage RUN mode, the drive
unloads the heads and they should be in a fixed position, here they
continue to reverse/forward but more slowly than in RUN mode.
Because the heads continues to mess around even in unload mode, this a
priori excludes alignment problems.
Here is a video of that issue:
https://youtu.be/HzzxLnSdEOg
Other information, if I cut the power while the drive is in RUN mode, it
does not do an emergency retraction of the heads, related problem?
I was hoping for a power supply problem but all the voltages and even on
the main board cage seem ok (with a multimeter).
If one of you had already encountered this problem of lack of head
stabilization and continuous reverse/forward on this type of drive?
Thanks !
Dominique
