You need a router with 3 eth interfaces.
break it down into 3 subnets. Routing between subnets will be done by the router
automatically.
As far as subnetting goes, pck up a book and read up on it or go to cisco's web
site.
-Apoorva
Niraj Palikhey wrote:
> Hi,
> If you are given a Class C network, eg. 207.96.46.0 and you had to create 3
> subnets for 3 floors of your bldg., how would you use routers to connect
> these 3 subnets and go out on the Internet? (Without using any internal
> addresses ie 10, 172, 192). I know that the mask is going to be
> 255.255.255.224 with 30 hosts on each subnet. My question is, do you connect
> these 3 subnets using the Ethernet interfaces or using the serial? And if
> you use either, what would be the ip addressess for the default gateways on
> all 3 subnets? How would the hosts on each subnet know how to get to the
> other subnet?
> Please advise.
> Thank you.
> Kind regards,
> [EMAIL PROTECTED]
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> ---
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
