In a message dated 10/8/00 8:53:45 PM Eastern Daylight Time,
[EMAIL PROTECTED] writes:
> > Hi everyone,
> >
> > Just messing around with a router did a show int token 0 command says:
> > Interface up, Line protocol down.
> > When you issue the no shut command on the interface it still says
> Interface
> > up, Line protocol down. Why is this?
>
> 'Cause nothing is physically connected to the interface, or, if it is, it
> is not working properly!
>
> Cheers,
> Saverio
>
Is it in it's initializing state by chance? Just a thought...
Mark Zabludovsky ~ CCNA, CCDA, 1/4-NP
<A HREF="mailto: [EMAIL PROTECTED]">[EMAIL PROTECTED]</A>
"If you need luck, apparently you're not prepared...Go study!"
~Mark Zabludovsky~
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]