can you replicate this? did you capture any debug output?
brian
On Wed, 22 Nov 2000, dennis rufolo wrote:
> Does anyone have a suggestion or solution???
>
> Frame Relay hub and spoke network. 2 central site 3640's each with a
> T1(on each) set to dlci 900
> on one and dlci 901 on the other.
>
> 85 remote locations, 1750's 56k wic1s 32k CIR. 42 mapped to dlci 900-
> 43 mapped to dlci 901.
>
> We are using eigrp on a 10.0.0.0 network. HERE is the question. ( by
> the way I have a current open T.A.C. case and they seem to be stumped)
>
> 4 remote locations dropped from our network. couldn't ping, telnet, or
> pass traffic--YET
> the show frame pvc # command on both the hub(3640) and the spokes(1750)
> showed ACTIVE.
> We were able to dial into the remote routers.
>
> After looking at all the obvious we tried to map a STATIC route and
> bang!!! the circuit came right back.
>
> Why is this needed at all when we are using eigrp? Why only on these 4?
>
> I would appreciate any ideas. Thanks
>
> Dennis Rufolo
> Ewing Irrigation Products
> Phoenix,Az.
>
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
-----------------------------------------------
Brian Feeny, CCNP, CCDP [EMAIL PROTECTED]
Network Administrator
ShreveNet Inc. (ASN 11881)
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
