Hi,
You may also need to run the CDP process.
router#(config)cdp run
Teunis
Hobart, Tasmania
Australia
On Thursday, January 11, 2001 at 04:18:47 PM, Roberts. Timothy wrote:
>
> I Should have included in my last email that I already performed the cdp
> enable command.
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, January 11, 2001 4:05 PM
> To: [EMAIL PROTECTED]
> Cc: [EMAIL PROTECTED]
> Subject: RE: Cant see CDP neighbor
>
>
> Robert make sure that you enable cdp on the interface. The command is "CDP
> enable". You have to be in config-interface mode. Let me know if this
> works??
>
>
> Eric Washington
> Banc Of America Securities - Japan
> Information Technology / IS
> [EMAIL PROTECTED]
>
>
>
> -----Original Message-----
> From: Roberts, Timothy [mailto:[EMAIL PROTECTED]]
> Sent: Friday, January 12, 2001 8:48 AM
> To: '[EMAIL PROTECTED]'
> Subject: Cant see CDP neighbor
>
>
>
> I have two routers connected back to back via two serial cables. I can ping
> each one from the other one. The problem is that they do not show up when I
> do a show cdp neighbor. I am sure that I am just overlooking something
> small.
> Thanks
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
>
--
www.tasmail.com
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
