Sound like you need a DCE cable for your the router :)
Take a close look at your cable or use the "show controllers Serial 0" to
verify you have the right one.
http://www.cisco.com/univercd/cc/td/doc/pcat/se____c1.htm
""Eric ding"" <[EMAIL PROTECTED]> wrote in message
984kvl$3dk$[EMAIL PROTECTED]">news:984kvl$3dk$[EMAIL PROTECTED]...
> two 2500 routers,routerA and routerB, back-to-back connection .both of
> them use serial 0,when i set routerA's serial for dce,i got the output
> below:
> routerA(config-if)#dce-terminal-timing-enable
> %not allowed on dte interface
> but if i use the command below:
> routerA(config-if)#no dce-terminal-timing-enable
> routerA(config-if)#dce-terminal-timing-enable
> it does work.
> i was confused about it!
> any suggestion will be appreciated!
>
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
