Robert,
Where have you been..? Haven't seen you in the group for
sometime. I was also wondering about Bob Envry of VA/DC/MD CPAW fame
haven't heard from him in a while as well.
Anyway, good to see that you're still around..(our famous cable guy)....:-)
Nigel..
----- Original Message -----
From: robert lowery <[EMAIL PROTECTED]>
Newsgroups: groupstudy.cisco
To: <[EMAIL PROTECTED]>; Eric ding <[EMAIL PROTECTED]>
Sent: Wednesday, March 07, 2001 8:58 AM
Subject: Re: strange question about dce setting?
> Have you tried to use a special crossover cable... that is db60 both ends
but wired with
> one end dce and the other dte. To make it work you add the command
clockrate 64000 (for
> example) on the interface that has the dce end. If you try to add
clockrate on the dte
> end ..it will not allow you to do so. If you do a show controler serial
(port no) it
> will tell you what type of end is attached.
>
> ps I sell these specials cables on ebay and direct.
>
> bob...aka barronvonpuppy
>
>
> Eric ding wrote:
>
> > two 2500 routers,routerA and routerB, back-to-back connection .both of
> > them use serial 0,when i set routerA's serial for dce,i got the output
> > below:
> > routerA(config-if)#dce-terminal-timing-enable
> > %not allowed on dte interface
> > but if i use the command below:
> > routerA(config-if)#no dce-terminal-timing-enable
> > routerA(config-if)#dce-terminal-timing-enable
> > it does work.
> > i was confused about it!
> > any suggestion will be appreciated!
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
