two 2500 routers,routerA and routerB, back-to-back connection .both of
them use serial 0,when i set routerA's serial for dce,i got the output
below:
routerA(config-if)#dce-terminal-timing-enable
%not allowed on dte interface
but if i use the command below:
routerA(config-if)#no dce-terminal-timing-enable
routerA(config-if)#dce-terminal-timing-enable
it does work.
i was confused about it!
any suggestion will be appreciated!
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
