"John Neiberger" <[EMAIL PROTECTED]> wrote:
> If you're using that router as just a frame relay switch and nothing
> else, there's no reason to run a routing protocol because it won't be
> routing!
well, it WILL be routing, but not IP...frame-relay using static DLCI routes.
Actually, is there a way to configure dynamic frame-relay routing? Like for
frame-relay SVC's? Inquiring minds WANT TO KNOW!
;-)
(guess you didn't go golfing, eh John? neither did I...)
-e-
>
> HTH,
> John
>
> >>> "Thomas" <[EMAIL PROTECTED]> 3/30/01 4:31:22 PM >>>
> Hi All - I am setting my 2501 as a frame-relay switch. Its 2 serial
> ports
> will be set as DCE for providing clock. Since I am trying to test the
> compatiability of between IGRP and EIGRP, does it matter if I don't run
> any
> protocol (such as RIP, IGRP, EIGRP...) on this 2501? Thanks All!
>
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]