Anyone know off the top of thier head if it's possible to configure F-t1
interfaces back to back? I have a "cross-over" cable where I hook up the TX
from one end to the RX of the other and vice verse, but this is unlike High
speed serial interfaces where you set a clock rate on one side, drop a
couple addresses, throw up HDLC encapsulation and you are off and running.
Any ideas?
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5139&t=5139
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
