You D MAN Thanks!
""Bob Timmons"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> I know it can be done using the FT1 on the 2524's
> (http://www.cisco.com/warp/public/471/75.html)
>
> I'm not sure this goes for all FT1's, though.
>
> > Anyone know off the top of thier head if it's possible to configure F-t1
> > interfaces back to back? I have a "cross-over" cable where I hook up
the
> TX
> > from one end to the RX of the other and vice verse, but this is unlike
> High
> > speed serial interfaces where you set a clock rate on one side, drop a
> > couple addresses, throw up HDLC encapsulation and you are off and
running.
> >
> > Any ideas?
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5143&t=5139
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
