I know it can be done using the FT1 on the 2524's
(http://www.cisco.com/warp/public/471/75.html)
I'm not sure this goes for all FT1's, though.
> Anyone know off the top of thier head if it's possible to configure F-t1
> interfaces back to back? I have a "cross-over" cable where I hook up the
TX
> from one end to the RX of the other and vice verse, but this is unlike
High
> speed serial interfaces where you set a clock rate on one side, drop a
> couple addresses, throw up HDLC encapsulation and you are off and running.
>
> Any ideas?
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5142&t=5139
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
